Programmable Universal Transmitter Rish ducer V604 - 1038

Transducer

Programmable Universal Transmitter Rish ducer V604 - 1038

Availability: In Stock
  • Pay with:
  • Category: Tools & Instruments
Rs. 6,124.00
  • Input variable (temperature, a variation of resistance, DC signal) and measuring range programmed using PC / Simplifies project planning and engineering (the final measuring range can be determined during commissioning). Short delivery times and low stocking levels.
  • Analog output signal also programmed on the PC (impressed current or superimposed voltage for all ranges between – 20 and + 20 mA DC resp. – 12 and + 15 V DC) / universally applicable. Short delivery times and low stocking levels.
  • Electric insulation between measured variable, analog output signal and power supply / Safe isolation acc. to EN 61 010.
  • Wide power supply tolerance / Only two operating voltage ranges between 20 and a maximum of 264 V DC/AC.
  • Standard Version as per Germanischer Lloyd.
  • Provision for either snapping the transmitter onto top-hat rails or securing it with screws to a wall or panel.
  • Housing only 17.5 mm wide (size S17 housing)/ Low space requirement. 
  • Other programmable parameters: specific measured variable data (e.g. two, three or four-wire connection for resistance thermometers, “internal” or “external” cold junction compensation of thermocouples etc,) transmission mode (special linearised characteristic or characteristic determined by a mathematical relationship, e.g. output signal = f (measured variable)), operating sense (output signal directly or inversely proportional to the measured variable) and open circuit sensor supervision (output signal assumes fixed preset value between – 10 and 110%, supplementary output contact signaling relay) / Highly flexible solutions for measurement problems.
  • All programming operations by IBM XT, AT or compatible PC running the self-explanatory, menu-controlled programming software, if necessary, during operation / No ancillary hand-held terminals needed. 
  • Digital measured variable data available at the programming interface/ Simplifies commissioning, measured variable and signals can be viewed on PC in the field. 
  • Standard software includes functional test program / No external simulator or signal injection necessary. 
  • Self-monitoring function and continuously running test program /automatic signaling of defects and device failure.